Hot Water Dispenser Repair

Hot water dispensers normally keep on working without any sort of routine maintenance.

There are, however, occasional hot water dispenser problems that may occur:

Problem: Hot water is leaking from the faucet.
A little hot water leaking from the faucet from time to time is normal. Water increases in volume as it heats, so a small amount of water may drip from the faucet to relieve the pressure inside the water tank under the sink.

If the leak is continuous, though, the shut-off valve needs to be repaired. That usually requires the help of a qualified technician.

Problem: The water is too hot.
Solution: The temperature control on residential hot water dispensers is normally factory-set. But, you can usually set it to a different temperature. Consult your owner's manual to learn how to set yours.

To avoid scalding, don't set the temperature above 120 degrees Fahrenheit.

Problem: Poor water pressure.
Solution: The amount of water coming from the hot water dispenser is primarily determined by the amount of water entering the tank below. If the water flow is unusually slow, though, the incoming water may be obstructed—either a valve isn't open all the way, or there's something blocking the tank output or faucet.

Rate This Article

OVERALL RATING Be first to rate this article!

YOUR RATING

Saving Rating...

Log-in to save your ratings!

Recommend This Article

Digg
Reddit
Del.icio.us

ServiceMagic Articles To-Go